| CONTAINMENT
& DUST BARRIERS
|
|
 |
ZIPWALL
DUST BARRIER SYSTEM
Easy to set-up, one
person can set-up a 20' Zipwall Barrier in 5 minutes. The
Zipwall locks the poly sheeting firmly against the
ceiling. The foot of the pole keeps it snug against the
floor. Can be used with any plastic sheeting, light canvas
or drop cloth.
|
 |
#860998
ZIPWALL KIT 12
Comes complete with
two poles that extend to 12' and 2 jacks.
|
 |
#860996
ZIPWALL KIT 20
Comes complete with
two poles that extend to 20' and 2 jacks.
|
 |
#861331 - Zipwall 4 Pack Plus
Package Includes:
- 4 Zipwall Spring
Loaded Poles
- 2 Foam Rail
- 4 GripDisk
- 2 Zipwall Zippers
- 1 Carry Bag
|
 |
#861215 ZIPWALL FOAM RAIL
This 5' bar, with its soft, spongy edge is attached to a
Zipwall pole and jack and extremely tight seal without the
need for tape. |
 |
#861216 ZIPWALL SIDE CLAMP
These side clamps ensure a tight seal against the wall,
when attached to the foam rail and supported by a Zipwall
pole. The side clamp presses the plastic firmly to the wall. |
 |
#860999
THE ZIPPER ENTRY/EXIT SYSTEM
This system easily
sticks to any surface. Provides easy entry and exit access
to work areas while preventing and reducing the release of
dust, dirt and heat. Easy to install.
|
 |
#860998
CARRYING BAG
The carrier holds six standard, 12 foot poles with jacks
attached. The bag can also accommodate six of the new 20
foot poles and six jacks, if they are unattached from the
poles.
|
 |
POLY SHEETING &
DISPOSABLE BAGS
#860870 9' x 12' 2 mil Poly
Sheeting
#861020 20' x 100' Clear 4 mil Poly Sheeting
#861000 20' x 100' Clear 6 mil Poly Sheeting
#861001 20' x 100' Black 6 mil Poly Sheeting
#860876 38' x 60' Clear 4 mil Disposable Bag (50/roll) |
|
|
POLY HANGERS |
 |
#861217 Poly Hanger #1
Hanger #1 supports one or more layers of poly in front
of walls, Hanger #1 slips behind wall molding and is
supported by the vertical leg of the molding. Hanger #1 can
also support Poly in front of masonry or paneling by
attaching with a small nail into a masonry or paneling joint
which can be easily patched after tear down. (100/pkg) |
 |
#861218 Poly Hanger #2
Hanger #2 supports one or more layers of poly in front
of walls. Hanger #2 clips over the horizontal leg of ceiling
wall molding. The prong makes hanging poly faster and
ensures it will stay up during the length of the job.
|
 |
#861219 Poly Hanger #3
Hanger #3 supports poly from ceiling grid and other
overhead objects. Poly is installed over the pin and is held
in place by a removable retainer. Hanger #3 supports both
horizontally and vertically for building full containments,
connecting tunnels, dust curtains, etc. (100/pkg) |
 |
#861220 Poly Hanger #4
Hanger #4 supports poly from many building components by
attaching with its 10" resealable cable tie or by other
fasteners.(100/pkg) |
